I get commissions for purchases made through links in this post.
Home emergencies can strike at any time, often when you least expect them. Whether it’s a burst pipe, a clogged drain, or a broken appliance, knowing how to handle some of these issues on your own can save you time and money. While some repairs are best left to professionals, many common problems can be fixed with a little know-how and the right tools. Here’s how to handle emergency home repairs without needing to call a professional every time.
1. Handle a Burst Pipe
A burst pipe can cause serious water damage if not addressed immediately. The first step is to shut off the water supply to your home. Locate the main water shut-off valve, usually found in the basement or outside near the foundation, and turn it off to stop the flow of water.
Once the water is turned off, assess the damage. If the burst is small and accessible, you may be able to patch it temporarily using a pipe repair clamp or rubber patch and hose clamps. These solutions can stop the leak long enough for you to contact a plumber for a permanent fix. If the burst is too large or you’re unsure of the cause, it’s best to call a professional immediately.
2. Fix a Clogged Drain
Clogged drains are one of the most common home repair issues, but many can be fixed with a few simple tools. Start with a plunger, ensuring it creates a seal over the drain. If the clog is in the sink or tub, use a cup plunger. For toilets, use a flange plunger designed for that purpose.
If plunging doesn’t work, try a drain snake or auger . These tools can reach deeper into the pipes to break up or pull out the blockage. For minor clogs, a baking soda and vinegar solution can work wonders. Pour half a cup of baking soda followed by half a cup of vinegar down the drain. Let it sit for about 30 minutes, then flush with hot water.
If these methods don’t solve the problem, you may need to call a professional plumber to avoid causing more serious issues.
3. Repair a Leaky Faucet
A leaky faucet is a simple fix for those who don’t mind a bit of DIY. The first step is to turn off the water supply to the faucet. You can usually find the shut-off valve under the sink.
Once the water is off, use a wrench to remove the faucet handle. Depending on the type of faucet, you may need to replace a worn-out washer , O-ring , or cartridge. These components are inexpensive and available at most hardware stores.
After replacing the faulty part, reassemble the faucet, turn the water back on, and check for leaks. If the faucet is still leaking, it might be time to replace the entire faucet or consult a plumber.
4. Fix a Running Toilet
A running toilet is a common annoyance but often a simple fix. First, remove the toilet tank lid and inspect the parts inside. A running toilet is usually caused by one of the following:
- Flapper valve: If the flapper doesn’t seal properly, water continues to leak into the bowl. Replace the flapper if it’s worn or damaged.
- Float: If the float is stuck or out of adjustment, the tank will keep filling. Adjust or replace the float as needed.
- Fill valve: If the fill valve is malfunctioning, you may need to replace it entirely.
Replacing these parts is usually inexpensive, and many toilet repair kits come with all the necessary components.
5. Repair a Broken Door Lock
A broken door lock is a security concern that needs to be addressed immediately. Depending on the issue, you may be able to fix it yourself.
If the key won’t turn, the problem could be due to a misaligned strike plate or dirty keyway. Use a lubricant like graphite powder or a silicone spray to clean the keyhole and test the lock again. If the lock is misaligned, gently tap the strike plate with a hammer to reposition it.
If the lock is completely broken or the mechanism is faulty, you’ll need to replace it. Most home improvement stores offer standard lock replacement kits that are easy to install.
6. Repair a Faulty Light Fixture
A flickering or faulty light fixture can usually be repaired with a few simple steps. First, make sure the power is turned off at the breaker box. If the light bulb is loose or burnt out, simply replace it with a new one. If the issue persists, you may need to inspect the wiring or switch.
If the wiring looks loose or damaged, you can attempt to reconnect it by stripping the wire ends and reconnecting them to the appropriate terminals. Always use wire nuts for a secure connection. If you are unsure about the wiring, it’s best to consult an electrician, as electrical work can be dangerous.
7. Unclog the Garbage Disposal
A clogged garbage disposal can quickly turn into a big mess. The first thing to do is to turn off the power to the disposal by unplugging it or switching off the circuit breaker. Use tongs or pliers to remove any visible obstructions inside the disposal.
If that doesn’t work, use a hex wrench to manually turn the disposal’s motor shaft. You can usually find the hex wrench in the disposal kit. Turn the motor shaft back and forth to dislodge the clog.
Once the obstruction is cleared, plug the disposal back in, and run cold water through it while turning the disposal on to test for functionality.
8. Fix a Squeaky Floorboard
A squeaky floorboard can be an annoying problem, but it’s easy to fix with a few tools. Start by locating the squeak and checking if it’s caused by a loose nail or screw. If it is, simply use a hammer or screwdriver to secure the board back in place.
If the squeak persists, you may need to use screws or floorboard adhesive to secure the boards more tightly. For larger areas, a floorboard repair kit might be required.
9. Fix a Hole in the Wall
Small holes in the wall are easy to patch. Use a spackling compound or wall repair paste to fill in the hole. After the compound dries, sand it smooth with a fine-grit sandpaper.
If the hole is larger, you may need to use a patching kit, which includes a mesh patch that you can place over the hole before applying the compound. Once the compound is dry, sand it smooth, then repaint the area to match the surrounding wall.
Conclusion
Home repairs don’t always require a professional, especially for common issues like leaks, clogs, and faulty fixtures. With the right tools and a little knowledge, many emergency home repairs can be handled by yourself. However, if you encounter a more complex issue or feel uncomfortable with a repair, don’t hesitate to call in a professional. Taking care of repairs as they arise can help keep your home safe and functional without the added expense of a professional visit.